Creating and Modifying Patterns

//coming soon

Creating a pattern

To begin, click the Draw High button on the toolbar. This will enable the drawing tool. You may then create the upper boundary of your pattern by left clicking on the chart to create 

points. You may create as many points as necessary to generate the pattern. You may draw anywhere within the drawing area. Right click to finish the upper line drawing then select the Draw Low button to begin drawing the lower boundary. 

If you make a mistake while drawing the pattern, you may click the “Clear” button on the toolbar to clear the line drawings and start over.

Modifying Patterns

You may modify the fuzzy logic parameters as needed after the pattern has been drawn. The default parameters may be used for most patterns, and should only be changed when absolutely necessary. These are considered “advanced” settings.